Design Optimisation
Engineering review of your drawings to reduce manufacturing cost without affecting function — tolerance relaxation, material alternatives and geometry simplification with concrete estimates before any change is made.
Many components arrive with tolerances tighter than the application requires, material grades more expensive than necessary, or geometries that add cost without adding function. We review your drawings with manufacturing in mind and propose specific changes — always with your approval before anything is modified.
- Tolerance review — identify dimensions that can be relaxed
- Material alternatives with equivalent or better performance
- Geometry simplification to reduce machining time
- Cost impact estimate for each proposed change
- No changes made without your written approval
What We Review
- Dimensional tolerances vs application requirements
- Surface finish specifications (Ra)
- Material grade — function vs cost trade-off
- Part geometry and machining complexity
- Assembly interfaces and fit requirements
- Finishing and coating specifications
What You Receive
- Marked-up drawing with proposed changes
- Written rationale for each modification
- Estimated cost reduction per change
- Risk assessment for each proposal
- Revised drawing once changes are approved
- No obligation to accept any proposal
Our position
We propose changes — you decide. Nothing in your drawing is modified without your explicit approval. If an optimisation proposal introduces any risk to fit, function or compliance, we say so clearly. The goal is cost reduction without compromise, not cutting corners without your knowledge.
Start a conversation
Tell us about your project — what you need, in what quantity, and when. We take it from there and get back to you within 48 hours.
Design Optimisation
Engineering review of your drawings to reduce manufacturing cost without affecting function — tolerance relaxation, material alternatives and geometry simplification with concrete estimates before any change is made.
Many components arrive with tolerances tighter than the application requires, material grades more expensive than necessary, or geometries that add cost without adding function. We review your drawings with manufacturing in mind and propose specific changes — always with your approval before anything is modified.
- Tolerance review — identify dimensions that can be relaxed
- Material alternatives with equivalent or better performance
- Geometry simplification to reduce machining time
- Cost impact estimate for each proposed change
- No changes made without your written approval
What We Review
- Dimensional tolerances vs application requirements
- Surface finish specifications (Ra)
- Material grade — function vs cost trade-off
- Part geometry and machining complexity
- Assembly interfaces and fit requirements
- Finishing and coating specifications
What You Receive
- Marked-up drawing with proposed changes
- Written rationale for each modification
- Estimated cost reduction per change
- Risk assessment for each proposal
- Revised drawing once changes are approved
- No obligation to accept any proposal
Our position
We propose changes — you decide. Nothing in your drawing is modified without your explicit approval. If an optimisation proposal introduces any risk to fit, function or compliance, we say so clearly. The goal is cost reduction without compromise, not cutting corners without your knowledge.
Start a conversation
Tell us about your project — what you need, in what quantity, and when. We take it from there and get back to you within 48 hours.